[Free] 2018(Mar) Dumps4cert Testinsides Juniper JN0-360 Dumps with VCE and PDF 81-90

Dumps4cert.com : Latest Dumps with PDF and VCE Files
2018 Mar Juniper Official New Released JN0-360
100% Free Download! 100% Pass Guaranteed!
http://www.Dumps4cert.com/JN0-360.html

Juniper Networks Certified Internet Specialist, – Service Provider (JNCIS-SP)

Question No: 81

What are two types of BPDUs in the Spanning Tree Protocol? (Choose two.)

  1. configuration

  2. hello

  3. topology change notification

  4. link state

Answer: A,C

Question No: 82

Which protocol is used by wired Ethernet to manage frame collisions?

  1. IEEE 802.3 active monitoring

  2. IEEE 802.5 active monitoring

  3. carrier-sense multiple access with collision avoidance

  4. carrier-sense multiple access with collision detection

Answer: D

Question No: 83

Which two statements are correct regarding BGP-signaled Layer 2 VPNs? (Choose two.)

  1. You must enable the Layer 2 VPN signaling NLRI.

  2. You must configure the virtual circuit identifier.

  3. You must specify the neighbor using the tunnel end-point IP address.

  4. You must define a unique site-identifier value.

Answer: A,D

Question No: 84

Which two statements are correct regarding LDP-signaled Layer 2 circuits? (Choose two.)

  1. You must enable the Layer 2 VPN signaling NLRI.

  2. You must configure the virtual circuit identifier.

  3. You must specify the neighbor using the tunnel end-point IP address.

  4. You must define a unique site-identifier value.

Answer: B,C

Question No: 85

You have a router with dual Routing Engines. You want to ensure that your users experience minimum downtime. You have decided to enable graceful Routing Engine switchover on the router.

Which output accomplishes this task?

  1. {master}

    user@R1-re0gt; show system snapshot Information for snapshot on hard-disk Creation datE. Nov 1 1 :5 :0 2012 JUNOS version on snapshot:

    jbase : 11.4R2 jcrypto: 11.4R2 jdocs : 11.4R2 jkernel: 11.4R2

    jpfe : M40-11.4R2

    jroute : 11.4R2

  2. {backup}

    user@R1-re1gt; show system switchover Graceful switchover: On

    Configuration databasE. Ready kernel databasE. Ready

    Peer StatE. steady State

  3. {backup}

    user@R1-re1gt; show system snapshot Information for snapshot on hard-disk Creation datE. Nov 1 1 :5 :0 2012 JUNOS version on snapshot:

    jbase : 11.4R2 jcrypto: 11.4R2 jdocs : 11.4R2 jkernel: 11.4R2 jpfe : M40-11.4R2

    jroute : 11.4R2

  4. {master}

user@R1-re0gt; show system switchover Graceful switchover: On

Configuration databasE. Ready kernel databasE. Ready

Peer StatE. steady State

Answer: B

Question No: 86

Click the Exhibit button

Dumps4Cert 2018 PDF and VCE

When the Junos configuration shown in the exhibit is applied to the router, which routes in the forwarding table will begin load-balancing packet flows?

  1. all routes in the forwarding table

  2. all OSPF routes in the forwarding table

  3. all BGP routes in the forwarding table

  4. all RFC1918 routes in the forwarding table

Answer: D

Question No: 87

Which two values displayed in the output from the show spanning-tree MSTP configuration command must match on all switches participating in the same MSTP region? (Choose two)

  1. root bridge identifier

  2. authentication checksum

  3. context identifier

  4. configuration digest

Answer: C,D

Question No: 88

Click the Exhibit button.

Dumps4Cert 2018 PDF and VCE

Which two statements are correct according to the output shown in the exhibit? (Choose two.)

  1. The peering session can pass inet-vpn routes.

  2. The peering session uses an altered route preference.

  3. The peering session is enabled for multihop support.

  4. The peering session is enabled for multipath support.

Answer: B,C

Question No: 89

What is contained in an IS-IS CSNP message?

  1. all of the headers of the LSPs in a router#39;s link-state database

  2. all of the IP routes in a router#39;s link-state database

  3. all of the IP routes in a router#39;s routing table

  4. all of the LSPs in a router#39;s link-state database

Answer: A

Question No: 90

You are configuring a trunk interface on an MX Series device and want to ensure that any outgoing frames associated with VLAN 100 are transmitted as untagged frames.

Which configuration will achieve this objective?

  1. routing-interface irb.0

  2. vlan-id-list [100]

  3. native-vlan-id 100

  4. vlan-id 100

Answer: A

100% Dumps4cert Free Download!
Download Free Demo:JN0-360 Demo PDF
100% Dumps4cert Free Guaranteed!
JN0-360 Dumps

Dumps4cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.